Continue holding the ODO reset button until the brake light disappears.

Once the word reset displays below the brake symbol, quickly release the button and press it again.

When the symbol for the desired brakes is displayed on the screen, press and hold the ODO reset until you see the word RESET below the symbol.

Depending on which sensor you replaced and would like to reset.

Press the ODO reset button a few times until you see the front or rear brakes symbol.

Continue holding the ODO reset button pressed until the next symbol comes up. First, a yellow triangle will show on the dash.

Press and hold the ODO reset button for about five seconds.

Make sure time is shown at the center of the instrument cluster.

If your BMW has a START button, press it without pressing the brake pedal.

Turn on the ignition but do not start the car.

Brake pads must have at least 80% of life remaining.

BMW brake light reset procedure can be performed for front or rear brakes.

Sometimes, you may have to perform the BMW brake reset procedure more than once.

Repair Carprog A1 Adapter for CAN BUS cummunicationīMW INPA 6.4.3, 5.0.6,5.0.

How to use BMW INPA software and cable K+DCAN How to install TIS2000 for GM Tech 2 scanner Install BMW INPA on WinXP Win7 Win8 Win10įree Download BMW E-sys V3.22.5 v3.2.61 v3.2.71įree ECM Titanium 1.61 with 26000 drivers How to Install Toyota TIS Techstream 14.10.028 If necessary, adjust/ initialize/ reset steering angle sensor via INPA software in the end. There were no new codes stored for DSC module. (3) files to be used are shown below JOBNAMEĮGS CAN bus speed error was no longer present after checking with INPA software. Choose IKEīelow “get coded” seems to be a list of all the modules that can be coded.Ĭhoose F4: Process ECU to code a SINGLE MODULE. NCS Expert is going to read VIN/ZCS/FA information from one of these modules. Not sure if it works on other models.Ĭhoose ECU, OK. WIFI BMW ICOM A2 emulator or BMW INPA K+DCAN cableīMW model example tested: E39 528iM and BMW E46 325CI. ICOM Rheingold engineering software INPA, NCS –expert (and others WinKFP, Ediabas etc) BMW Scanner V1.4.0 Pa-soft will read coding data, but not able to decode. Or the module is new and needs programmed and initialized. Seem to purchase a used module, so the VIN is wrong and does not match the vehicle. Have the red brake light yellow DSC and red ABS on the dashboard.

Bmw 2006 e90 reset brake with inpa